AUDIOSOURCE AMP300 Stereo Power Amplifier
ONLY 2 LEFT!

The AMP300 from AudioSource was designed from the ground–up, with the distributed audio installer in mind.
Auto switching line level inputs, with assignable speaker level input allows easy incorporation into existing distributed audio systems. 2ohm output stability is especially beneficial since a total of four pairs of speakers may be connected to a single amplifier without concern for impedance protection. “Hidden” rear panel master volume controls, with front panel fine-trim adjustment enables the installer to set limits without concern for unwanted future adjustment by the end user.

Features:

Front panel controls for level and balance trim

A/B speaker outputs with front panel selection

Two sets of stereo input pairs

Auto–switching between inputs, with adjustable delay

Speaker level input which may be assigned to either input #1 or #2

Line level pass through output on input #2

Rear mounted master level controls (allows gain limiting)

Manual or auto–sensing power control

12V trigger input allows power–on command from external components

12V trigger output allows amplifier to trigger external components

Stereo and bridged mono operation

Heavy–duty binding post speaker outputs

2ohm stability

Discrete output components

THD: <0.05% (at 8ohm)

Dimensions: 5-1/4" (H) x 16.5" (W) x 14" (D)

Power Ouput: 235W RMS x 2 Channels @ 4ohm 375W RMS bridged mono @ 8ohm